Lync Troubleshooting: Your audio device may cause an echo

Lync Troubleshooting: Your audio device may cause an echo

Symptoms

If other people are complaining that they hear an echo when they are on an audio call with you, it might be caused by the audio device you are using.

Resolution

  • You can turn down your speaker volume to reduce the echo.
  • If your microphone or audio device is near a wall or other reflective surface that does not absorb sound, consider moving the microphone or changing its direction away from the reflective surface, so as to reduce potential echoes.
  • If you’re using your webcam’s microphone or if you are using your computer speakers, try using a different audio device such as a headset, handset, or standard microphone.
  • If possible, try placing the microphone as far away as possible from the computer speakers because audio output from the speakers may feed into the microphone and produce echoes.
  • If you are using a laptop with an integrated sound card that supports Microphone Boost, try disabling Microphone Boost to isolate the issue:
    • Click Start, and then click Control Panel.
    • In Control Panel, click Hardware and Sound, and then click Sound.
    • In the Sound dialog box, on the Recording tab, select your microphone, and then click Properties.
    • In the Microphone Properties dialog box, on the Levels tab, uncheck the Microphone Boost check box (if available).

    Make sure the device you are using is optimized for Microsoft Lync communications software. For a list of optimized devices, see Phones and Devices Qualified for Microsoft Lync.

     

    Related Issues

    <Please add links to similar problems or solutions>

    Community Resources

Leave a Comment
  • Please add 4 and 3 and type the answer here:
  • Post
Wiki - Revision Comment List(Revision Comment)
Sort by: Published Date | Most Recent | Most Useful
Comments
Page 1 of 1 (1 items)
Wikis - Comment List
Sort by: Published Date | Most Recent | Most Useful
Posting comments is temporarily disabled until 10:00am PST on Saturday, December 14th. Thank you for your patience.
Comments
Page 1 of 1 (1 items)